Lude Generation

Posted: **Wed Apr 29, 2015 9:34 pm**

Could someone do me a massive favour please. Could someone measure a couple of bits on a 4th or 5th gen as I'm looking to possibly do a H22 swap in the truck.

The measurements I could do with are:
- the distance from strut centre to strut centre for the front struts
- the track width (outside edge tyre to tyre on the front)
- approximate height of the engine from bottom of sump to top of the rocker

That'll give me an idea on if it will actually fit.

Cheers.

Posted: **Tue May 05, 2015 9:39 pm**

Anyone??

Posted: **Tue May 05, 2015 10:28 pm**

Crazy_C wrote:
The measurements I could do with are:
- Nitins winky size

That'll give me an idea on if it will actually fit.

Cheers.

6" IIRC

Posted: **Tue May 05, 2015 10:29 pm**

Your ruler must be broken Ratty...

Posted: **Tue May 05, 2015 11:04 pm**

wurlycorner wrote:Your ruler must be broken Ratty...

No, that's just called wishful thinking!

Posted: **Tue May 05, 2015 11:32 pm**

wurlycorner wrote:Your ruler must be broken Ratty...

Ruler?

I was taught to use "other" methods of measurement.

Posted: **Tue May 05, 2015 11:42 pm**

Posted: **Tue May 05, 2015 11:52 pm**

RattyMcClelland wrote:
wurlycorner wrote:Your ruler must be broken Ratty...
Ruler?

I was taught to use "other" methods of measurement.

Dip test?

Posted: **Wed May 06, 2015 12:04 am**

4thgenphil wrote: Dip test?

Precisely. Like a dip stick there is a min and max measurement Mark roughly an inch apart.

Lude Generation

Some measurements required

Some measurements required