Valve clearance tool

andypont · Post by **andypont** » Fri Jun 07, 2013 7:56 am

Just get yourself a 10mm box spanner.. like this.
http://www.ebay.co.uk/itm/TM1-Metric-Bo ... 782wt_1161

A ring spanner on the top to drive, flat screwdriver down the centre to access the adjuster screw.
Add set of feeler gauges and you have the full kit!!

Post by **vanzep** » Fri Jun 07, 2013 8:03 am

^^^^
this is what i told you yesterday Michael - even offered to help you.

Post by **vanzep** » Fri Jun 07, 2013 8:14 am

yeah go ahead and buy one - i think they are about £20 - we can all chip in

andypont · Post by **andypont** » Sat Jun 08, 2013 9:49 pm

newkid wrote:
vanzep wrote:^^^^
this is what i told you yesterday Michael - even offered to help you.
Yea you did but Indi is planning on doing his as well so figured id get the ball rolling on maybe having the proper tool for us both

Fair comment, but I think it might cost you as much in postage to send a borrowed one backwards and forwards than it would for you each to get a box spanner.
I don't think the job is any easier (or less fiddly) with the proper tool, though that is just my opinion. Food for thought.

JDM-BB4 · Post by **JDM-BB4** » Sun Jun 09, 2013 9:15 am

Argh I have one of the 10mm valve adjustment tools here I could have lent you guys.
I was in Edinburgh yesterday as well, but had not seen this thread.

Post by **indigolemon** » Sun Jun 09, 2013 12:02 pm

I've not done my valve clearances yet, so there's still time!

LewisH · Post by **LewisH** » Sun Jun 09, 2013 12:18 pm

I bought mine from Wilco for £5 (the feeler tool thing anyway) the rest i had already.

Lude Generation

Valve clearance tool

Re: Valve clearance tool