5th gen hubs for 5 stud conversion

RAZOR · Post by **RAZOR** » Thu May 10, 2012 2:48 pm

anyone going to japfest got any 5th gen hubs?? not sure what else i shall need for the conversion but any help or advice would be appreciated. thanks!!
Dan

Post by **cebul** » Thu May 10, 2012 3:32 pm

Have got a full 5 studs conversion mate but I will not to be able to remove it before event mate.
Pm me if you interested.

A1ex · Post by **A1ex** » Thu May 10, 2012 3:50 pm

I have some 5stud rear hubs I can bring to japfest if your going? They're from an ATR but pretty sure they'll fit...

RAZOR · Post by **RAZOR** » Thu May 10, 2012 4:39 pm

other than hubs what else will i need?

mercutio · Post by **mercutio** » Thu May 10, 2012 4:42 pm

you need either big washers that will go over the cv joint end if your using 4g driveshafts other than that you need 5g driveshafts and cv's afaik

RAZOR · Post by **RAZOR** » Thu May 10, 2012 4:50 pm

when u say cv's do u mean the hub end of the shaft?

mercutio · Post by **mercutio** » Thu May 10, 2012 10:18 pm

yes matey but let me check if i have the details right about which shaft to use or you can just check on preludepower.com