4G UKDM SRS ECU

Post by **Ammo** » Fri Jan 25, 2013 4:17 pm

Yeah mines the Type I (twin airbags)

Not desperate, cars still needs a lot of work before a MOT, if your dumping the whole lot I might get the sensors and loom off you if your stripping it that far, as I can't figure out what is actually wrong with it

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Fri Jan 25, 2013 4:21 pm

Yeah that's cool, although I have already sold the drivers rear sensor. But the rears are switchable by just removing and reattaching the brackets.

The wiring might be a pain though as some of it is wired in with some other stuff. Leave it with me and a day in the garage (

) and I'll see what I can get removed for you.

Post by **Ammo** » Fri Jan 25, 2013 4:24 pm

Well ECU is a deffo, hoping that fixes it.

I've swapped both airbags and the srs reel and still got the light on, so if I swap the ECU I will at least know it's something else

Rear sensors? I though they only had sensors in the front firewall?

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Fri Jan 25, 2013 4:34 pm

Sorry thought you meant the speed sensors - they use the info from these too as far as I remember. But yeah the impact sensors, just two in the front footwells - I'll get these.

VT3C RUNN3R · Post by **VT3C RUNN3R** » Fri Jan 25, 2013 4:50 pm

I also have a 93 UKDM with both driver and pass airbags available. Your more than welcome to come have a butchers at it if you like, or if its not too difficult to remove I can do it and meet you halfway in the likes of pboro or something. wouldnt be looking for anything for it.

Post by **Ammo** » Fri Jan 25, 2013 4:58 pm

It's a bit of a pain to get at, I don't mind removing it. Is the UKDM going to be scrapped? (means I don't have to put it back together lol)

VT3C RUNN3R · Post by **VT3C RUNN3R** » Sun Jan 27, 2013 11:06 pm

Lol you dont have to worry bout putting it back together, its a donor

Post by **Ammo** » Sun Jan 27, 2013 11:16 pm

Donor you say! what are the rear arches like? need some bits to weld into my UKDM

VT3C RUNN3R · Post by **VT3C RUNN3R** » Mon Jan 28, 2013 7:42 pm

The rear arches are no good I'm afraid bro, they''re full of filler already. Its had dodgy repairs on 4 corners

Post by **Ammo** » Mon Jan 28, 2013 8:50 pm

Bit I need is before the arch and after the door about mid point of the 2 on the drivers side