Low comp pistons

Danni22 · Post by **Danni22** » Sat Mar 02, 2013 1:33 pm

Yehh iv done some research on the and they do have mixed reviews. Best bet would be a sleeved block but it is a big cost..

Dose anyone no what the standard H22 rods can take?

EG_H22 · Post by **EG_H22** » Sat Mar 02, 2013 4:42 pm

Ive been advised to use forged rods.
But have been given a wicked price on sleeves and machine work which fronttobacksidetoside knows.

Waiting in a reply from the guys to see if there could be a deal met as we are both going for the same thing.

Post by **4thgenphil** » Sat Mar 02, 2013 6:36 pm

EG_H22 wrote: Waiting in a reply from the guys to see if there could be a deal met as we are both going for the same thing.

i could be tempted to get all over that if the price is right

EG_H22 · Post by **EG_H22** » Sat Mar 02, 2013 7:38 pm

Trust me the price is right mate.
All he needs is the block, sleeves and pistons, the sleeves they get as they're shipped in.
Pm if your tempted bro can put another person down

mercutio · Post by **mercutio** » Sat Mar 02, 2013 8:18 pm

when is this likely to happen?

Post by **4thgenphil** » Sat Mar 02, 2013 8:36 pm

mercutio wrote:when is this likely to happen?

+1

to be honest i may just leave the bores as is and get them hooned at a later date

EG_H22 · Post by **EG_H22** » Sat Mar 02, 2013 10:17 pm

Im buying my pistons in two weeks, the company im using will be purchasing the sleeves for me £600 for wet sleeves.
End of the month hopefully and i should have a forged block to handle serious power

Post by **4thgenphil** » Sat Mar 02, 2013 10:41 pm

can i supply my own sleeves?

EG_H22 · Post by **EG_H22** » Sun Mar 03, 2013 7:52 am

U can, but the bloke was funny when i said that i was planning on getting my own as i can get them between £470-£570 depending who i fancy. He was likethere alot of fakes going around and if we fit them and it cracks or what not then its the companies rep that gets put on the line u know.