wanted - 4th gen-rear lca to subframe bolt

[vanzep]

Im in need of the lca to subframe bolt for my 1994 4th gen 2ws BB4 sivtec-any bolt from 4th gen with 2ws should do i think-im not sure if the 4ws model will have the same bolt...probably does
Just couldnt get the bolt out - it just kept spinning so will need to cut it out hence the need for a replacement one - either side will do as theyre both the same.
And of course it was the last bolt that gave us the problem.
Cheers
Nick

[4thgenphil]

think they are different from a 4ws as the have camber adjustment!

[vanzep]

cheers for that Phil - ive just looked at lings catalogue and it shows the bolt i need which is item 55 but its not listed-they only list the 4ws camber adjust type bolt. so i will have to go in and see the Honda main dealer for this one - If i remember right they sent Merlin the wrong bolt when he was doing his recent polybushing work

[Vtecmec]

ive just looked at lings catalogue and it shows the bolt i need which is item 55 but its not listed-they only list the 4ws camber adjust type bolt.

The catalogue only lists the parts for the car that you put in the initial list, so you need to choose the 2WS model first. The picture is generic and shows parts on all models.

[Ammo]

Use the 2L model as it's the only UKDM that didn't have 4ws

Think a 4ws one cost me £12 from Honda, robbing bastards!

[Merlin]

I had no problem with the bolt from Honda. If they give you any beef about not being able to fine the correct part number look on lings and use the UKDM 2.3L 2WS bolt part number (thats what I used to it will work 100%) and go back to Honda. As Ammo says, £12 for the bolt.

[vanzep]

Cheers guys - will look it up under the 2.3/2ws model on lings.

[4thgenphil]

they do have them although they may take a few days to turn up!

[bluejackhustler]

I've put some photo's on LB for you Vanzep, too see if thats what you're after!!!

[vanzep]

cheers bluejack ive replied to that