Lude Generation

Firstly, I know the driveshafts on the type s are different to the standard shafts length wise, but are the inner c.v joints the same throughout the 2.2 manual range? i have noticed the inner joint on the near side of my type s is split and completely dry. it has a bit of a knocking in it too. so if they are interchangeable....

i need an inner c.v joint for my lude. left side/nearside. so @w1ggs do you have one from your lude that i am seeing tomorrow if they are the same? @rattymcclelland @nitin_s1 are they compatible?

also i have noticed the drop links on the front have play too, so any recommendations or sites ?

also front lower ball joints, all 4. where do i get these from. the s has 2 lower front ball joints, where as the standard lude only has 1. so again are these compatible and where have people bought these from?

I think the CV joints are the same.
As for the Type S suspension parts. Either USA or lings in the VTi-S section of the UK prelude.

Sam, if you want oem parts just give me some part numbers or ur reg/chassis number and I can see if I can get them any better with my discount . Some parts are not much cop with discount tho

cheers chris.
items 3 and 4 perhaps?

http://www.lingshondaparts.com/honda_ca ... k_03=23317

ratty, would you say im right with these?

blueprint make the type s droplinks mate. any motor factor should carry them on order.

No problem. I am pretty sure that the joint will come naked tho, as in you would need the boot and boot retainer too chap. It's then it gets expensive

honda-hardy wrote:cheers chris.
items 3 and 4 perhaps?

http://www.lingshondaparts.com/honda_ca ... k_03=23317

ratty, would you say im right with these?

Yep.

Make sure you go on chassis number too, as they are two different numbers

we'll there you go, all info there