Lude Generation

Im looking to replace the open end type wheel nuts that i have with some closed end type ones
Thought i would check on here first
Open to what you have but bear in mind they will be going on newly refurbed wheels so need to presentable.
Theyre going onto my BB4 so only 16 nuts needed.

I think @Honda-hardy has some of the short ones that fit under a centre cap.

cheers - they can be short or standard length
will see what sam has

We have like a million of these at work shame I'm not there for two weeks

got loads bud. over 40 of the buggers, brand new too. genuine honda.

£12 posted for 16
£15 posted for 20

I just got these:

http://www.ebay.co.uk/itm/230917420961? ... 1439.l2649

Cheap enough, steel not aluminium, perfectly presentable for your new wheels.

honda-hardy wrote:got loads bud. over 40 of the buggers, brand new too. genuine honda.

£12 posted for 16
£15 posted for 20

thanks sam - can you pm or post up a couple of pics

Gayno wrote:I just got these:

http://www.ebay.co.uk/itm/230917420961? ... 1439.l2649

Cheap enough, steel not aluminium, perfectly presentable for your new wheels.

They look fine Good choice

those nuts in the link are tapered the nuts i have are ball.



you need to decide what you want. i can only gaurantee safe use on genuine honda wheels not any other after market.

hmmm theyre going on my piaa wheels - ive got a couple of the nuts that were on the wheels when i bought the car - they look like the tapered type. Thanks for the help sam but i think i will go with the ones that @Gayno mentioned

no worries