Lude Generation

Hi guys. So, finally got the motor in the air to sort out this crank pulley business and turns out the previous owner had attempted to weld the pulley on so as a result, it I can't get rid of these sordid welds, I might need a new crank.

I had a look at the bin on my car and it says the engine should be a h22a8 but had a look on the engine and it just says h22a. So I'm presuming they're 2 different motors and it's had a replacement one put in for whatever reason.

As a result I'd like one for the h22a. Cash waiting

i have a spare h22 bottom end with no pistons for sale for £50, or i could take the crank out for £30 instead - plus postage as well, i can get a quote for that if you wish

What size block is it drax? Can u measure the bores?

4thgenphil wrote:What size block is it drax? Can u measure the bores?

sure, will "tape measure" measurements be enough? otherwise ill need to borrow a digital measuring device

plus im guessing you require bore width?