Lude Generation

After 2 dust cover washers if anyone has any spare from old shocks, there basically big washers, if not its off to honda to be bent over

did the stuff arrive buddy

Yes mate, got the rears painted and fully rebuilt, just the fronts to do now.

Could you not just go to B&Q and get some that are approx the same size? Would they be cheaper?

Front or rear ?

Merlin wrote:Could you not just go to B&Q and get some that are approx the same size? Would they be cheaper?

I bought some repair washer off ebay a while back to be use for curing rear shock knock they are very similar size od and id to the part you are looking for but are quite a bit thinner so you would have to use a couple of them.
here is a pic to show the comparison - the one on the right is the repair washer


comparison of dimensions:

oem od 38mm x id 12mm x 4mm thick
vs
repair washer od 40mm x id 13mm x 1.5mm thick

pic of repair washer on koni front shock dust cover - fits ok



ive got some spares of the repair washers if you need.

got a pm from you @newkid saying i had been tagged in this topic
but nothing here?
thats not you posting up and then deleting again is it
anyway parts are here if you need

vanzep wrote:got a pm from you @newkid saying i had been tagged in this topic
but nothing here?
thats not you posting up and then deleting again is it
anyway parts are here if you need

Yes was me I couldn't word it right so it always looked wrong, sending a text as be easier bud.

well glad we got a couple of the metal washers sorted for you - now it looks like you just need a couple of the white koni plastic washers to finish the job- i will measure up the ones i have here and drop u a pm - at least with the measurements you can get something very similar that will do the job and should only cost pennies.

thanks for the other 4th gen bits and pieces you dropped off - much appreciated

No worries bud. Was good to catch up after so long. Wont make it as long next time.