Page 1 of 2
BB4 DRIVESHAFT & HALF SHAFT NEEDED ASAP
Posted: Wed Mar 09, 2016 2:43 pm
by lewie fraser
Need a bb4 driveshaft and half shaft asap.
Need it tomorrow if possible as cars already up on ramps so will make my life a lot easier!
Hopefully someone locally around Dundee can have one to pick up? thanks in advance
Posted: Wed Mar 09, 2016 2:52 pm
by Merlin
Any 4th gen drive shaft will do. It can be a UK BB1.
Posted: Wed Mar 09, 2016 3:10 pm
by lewie fraser
Merlin wrote:Any 4th gen drive shaft will do. It can be a UK BB1.
can you also use ATR?
Posted: Wed Mar 09, 2016 3:18 pm
by Merlin
I don't think so.
Posted: Wed Mar 09, 2016 3:58 pm
by vanzep
I think you can - sure only difference is in the intermediate shaft
atr driver side looks same and atr pass side looks to be same or approx 5mm shorter - i couldnt tell for sure on pass side as id knocked hell out the prelude one trying to get the outer cv off and this may have made the prelude one longer by 5mm
lewie your welcome to try them and return them if theyre no good but im confident they will work. its just the outer cv on the pass side is a bit stiff - might just be from sitting around so long...
ive got a prelude intermediate shaft and atr driver and pass side - so a full set.
Posted: Wed Mar 09, 2016 4:14 pm
by preludemanh22
I've got these from a automatic though ??
Posted: Wed Mar 09, 2016 4:16 pm
by vanzep
nooooooo we dont want that
Posted: Wed Mar 09, 2016 4:16 pm
by Merlin
The auto is slightly different as it does not use a half shaft but it has one long shaft instead. I am not sure how this bolts up.
Posted: Wed Mar 09, 2016 4:46 pm
by lewie fraser
vanzep wrote:I think you can - sure only difference is in the intermediate shaft
atr driver side looks same and atr pass side looks to be same or approx 5mm shorter - i couldnt tell for sure on pass side as id knocked hell out the prelude one trying to get the outer cv off and this may have made the prelude one longer by 5mm
lewie your welcome to try them and return them if theyre no good but im confident they will work. its just the outer cv on the pass side is a bit stiff - might just be from sitting around so long...
ive got a prelude intermediate shaft and atr driver and pass side - so a full set.
Thanks Nick! Yeah I ll take them and see how it goes.only down side is having to get to Edinburgh either tonight or tomorrow morning.. Don't suppose you fancy a drive to Dundee or perth?
or I could meet you half way
Posted: Wed Mar 09, 2016 5:04 pm
by vanzep
sent u pm - can meet you half way if that helps