Page 1 of 1

WANTED: 3rd Gen Facelift - Ideally Manual 4WS

Posted: Mon Jan 02, 2017 10:18 am
by Metalhead
I've come to the conclusion that I sadly need a donor car to complete my ongoing restoration. I hate taking another Prelude off the road but needs must on this occasion.

Ideally looking for a facelift (90-92) 3rd Gen 2.0i 4WS with manual gearbox but will consider an auto. Not bothered if no MOT but the closer to the North West the better to keep flatbed transportation costs to a minimum.

Car must have :-

Door strips in good conditions (these are the rubber 'bump strips' halfway up the outside of the car). They should have no splits or blistering of the rubber.

Owners Manual and Handbook
Toolkit (complete)
All window trims in good order
Intact rear bumper
PAS cooler that isn't just a collection of rust (!)

Please PM me if you have something that fits the bill.

~Phil.

Posted: Fri Jan 06, 2017 12:50 pm
by Hondaboy

Posted: Fri Jan 06, 2017 1:07 pm
by Hondaboy
Trying to figure out this image uploading nonsense god I'm rubbish at all this malarkey Image

Success
Pics don't do this justice it's the best one I've seen so far and solid
Just cosmetic rust no crumbling

Also have rear bumper and maybe door seals and rubbing strips though that will take some digging to find

Posted: Fri Jan 06, 2017 3:35 pm
by Metalhead
Wow! I've just bought some pipework to build a custom cooler but this looks good! How much are you looking for? Whereabouts are you? What's left of the car as I need quite a lot of bits.

Full Lock Set (5) inc. seat release and petrol flap lock next to drivers seat.
Drivers and Pass side strips
Section of metalwork at base or rear arches (both sides) where the bumper attaches - mine have gone.... will have to fabricate if nothing better comes along

Image

~Phil.

Posted: Fri Jan 06, 2017 4:40 pm
by Hondaboy
I'm in Glasgow but will post anything
£20 plus postage costs will do for me
I've got almost every component of the car but no body it got cut up and scrapped as it was rotten

Posted: Fri Jan 06, 2017 4:42 pm
by Metalhead
Nice - I'll send you a PM!