Page 1 of 1
5th gen hubs for 5 stud conversion
Posted: Thu May 10, 2012 2:48 pm
by RAZOR
anyone going to japfest got any 5th gen hubs?? not sure what else i shall need for the conversion but any help or advice would be appreciated. thanks!!
Dan
Posted: Thu May 10, 2012 3:32 pm
by cebul
Have got a full 5 studs conversion mate but I will not to be able to remove it before event mate.
Pm me if you interested.
Posted: Thu May 10, 2012 3:50 pm
by A1ex
I have some 5stud rear hubs I can bring to japfest if your going? They're from an ATR but pretty sure they'll fit...
Posted: Thu May 10, 2012 4:39 pm
by RAZOR
other than hubs what else will i need?
Posted: Thu May 10, 2012 4:42 pm
by mercutio
you need either big washers that will go over the cv joint end if your using 4g driveshafts other than that you need 5g driveshafts and cv's afaik
Posted: Thu May 10, 2012 4:50 pm
by RAZOR
when u say cv's do u mean the hub end of the shaft?
Posted: Thu May 10, 2012 10:18 pm
by mercutio
yes matey but let me check if i have the details right about which shaft to use or you can just check on preludepower.com