H22a (closed deck) Block
Posted: Thu Feb 01, 2018 12:45 pm
After a closed desk block for some machining work to 89mm
bare bottom end bud or complete block?ctrsam wrote:After a closed desk block for some machining work to 89mm
Page 1 of 1
Posted: Thu Feb 01, 2018 12:55 pm
Posted: Thu Feb 01, 2018 1:13 pm
Bare block
it will be machined, sleeved and rebuilt
it will be machined, sleeved and rebuilt
Posted: Thu Feb 01, 2018 2:26 pm
Ive got this that’s just sitting in my garage, I only want the bits that bolt onto it
http://www.ludegeneration.co.uk/honda-p ... 21042.html
http://www.ludegeneration.co.uk/honda-p ... 21042.html
Posted: Thu Feb 01, 2018 3:39 pm
might be best to say where you are so you can find one close to home 
ive got a closed deck H22a block - ive refurbed the head but not started work on the block- engine came out of low mileage jdm vtec auto
Part is in Edinburgh
ive got a closed deck H22a block - ive refurbed the head but not started work on the block- engine came out of low mileage jdm vtec auto
Part is in Edinburgh
Posted: Thu Feb 01, 2018 4:42 pm
Sorry I should have said im in Derby
Can travel reasonably else if something can be stuck on a pallet and shipped straight to Vtec Direct that would be ideal
Can travel reasonably else if something can be stuck on a pallet and shipped straight to Vtec Direct that would be ideal