4th gen bits and pieces wanted

[rrobis]

Hi all,
looking for rubber cap for low beam that comes on 4th gen headlights (part 11)
and also the plastic bit in the front mount that holds the bonnet support rod, shipped.

offers here or PM.

unfortunately i don't have the pictures of bits i'm after, since i'm missing them ATM and I cannot find the plastic bit picture anywhere

[Scott560]

If they are the same as 5th gen I have some?

Sent from my MIX using Tapatalk

[Drax]

i have a few spare i think bud, here's one at least - a fiver plus shipping will do


i dont have the plastic bit to hold the bonnet catch in place unfortunately, and im on the lookout for one myself lol

[vanzep]

Bonnet strut bush and rod clip are available from ebay for £0.99 for the set

https://www.ebay.co.uk/itm/Set-Hood-Sup ... 4674391ae7

[Drax]

Bonnet strut bush and rod clip are available from ebay for £0.99 for the set

https://www.ebay.co.uk/itm/Set-Hood-Sup ... 4674391ae7

of course, you told me about this recently cheers Vanzep!! ill order them now

[firstlude]

Bonnet strut bush and rod clip are available from ebay for £0.99 for the set

https://www.ebay.co.uk/itm/Set-Hood-Sup ... 4674391ae7

just ordered one thanks

[vanzep]

[rrobis]

Thanks Vanzep for the tip.
Ordered as well

Sent from my Mi A1 using Tapatalk

[Drax]

Bonnet strut bush and rod clip are available from ebay for £0.99 for the set

https://www.ebay.co.uk/itm/Set-Hood-Sup ... 4674391ae7

well the bonnet support is great


but the plastic push clips would never go over the rod here

or from the other end. the hole in the middle is much too small on both plastic ones provided, even with the "easing" in with a hammer/drill to make the hole bigger. ah well, tis only 99p and sorted 1/2 issues

[vanzep]

sorry Drax i have just seen this post

i have fitted the larger bushing onto the bonnet stay/rod - i just made a cut in it on one side using a hacksaw and prised it open so it fitted on no problem.