Page 1 of 2
4th gen bits and pieces wanted
Posted: Mon Apr 30, 2018 7:47 pm
by rrobis
Hi all,
looking for rubber cap for low beam that comes on 4th gen headlights (part 11)
and also the plastic bit in the front mount that holds the bonnet support rod, shipped.
offers here or PM.
unfortunately i don't have the pictures of bits i'm after, since i'm missing them ATM and I cannot find the plastic bit picture anywhere
Re: 4th gen bits and pieces wanted
Posted: Tue May 01, 2018 10:01 pm
by Scott560
If they are the same as 5th gen I have some?
Sent from my MIX using Tapatalk
Posted: Wed May 02, 2018 10:28 am
by Drax
i have a few spare i think bud, here's one at least - a fiver plus shipping will do
i dont have the plastic bit to hold the bonnet catch in place unfortunately, and im on the lookout for one myself lol
Posted: Wed May 02, 2018 12:21 pm
by vanzep
Bonnet strut bush and rod clip are available from ebay for £0.99 for the set
https://www.ebay.co.uk/itm/Set-Hood-Sup ... 4674391ae7
Posted: Wed May 02, 2018 1:19 pm
by Drax
of course, you told me about this recently
cheers Vanzep!! ill order them now
Posted: Wed May 02, 2018 7:30 pm
by firstlude
just ordered one thanks
Posted: Wed May 02, 2018 10:04 pm
by vanzep
Re: 4th gen bits and pieces wanted
Posted: Fri May 04, 2018 10:39 am
by rrobis
Thanks Vanzep for the tip.
Ordered as well
Sent from my Mi A1 using Tapatalk
Posted: Thu May 10, 2018 2:45 pm
by Drax
well the bonnet support is great
but the plastic push clips would never go over the rod here
or from the other end. the hole in the middle is much too small on both plastic ones provided, even with the "easing" in with a hammer/drill to make the hole bigger. ah well, tis only 99p and sorted 1/2 issues
Posted: Mon May 14, 2018 4:25 pm
by vanzep
sorry Drax i have just seen this post
i have fitted the larger bushing onto the bonnet stay/rod - i just made a cut in it on one side using a hacksaw and prised it open so it fitted on no problem.