Lude Generation

hi everyone,as the title says.I am in need of a rear offside spindle for my 1995 bb4.I have the part number but cant find it anywhere,,,,HELP.I have changed the rear hub with new bearing but problem still there

i dont know what a spindle is myself can you post the part number please for us to look it up?

I think it's the shaft that the rear wheel bearing hub slips over and the nut threads onto.

yes vtecmec lol thats the bit.Stub axle is it? the part number is 52250_SS0_980 it says item decription spindle....

That is weird one - surely the spindle must be ok unless it has had a very hard impact that has misshaped it but even then if the hub and bearing fit on to it then it should be ok as that is the moving part - the spindle doesnt move.
I have a few hubs with good bearings if you want to try again - but i dont think you will find a used spindle anywhere as it would be very difficult to remove from the knuckle- so you might be better looking for a complete arm assembly.

What is the problem that you're having?

cheers vanzep and ek9sid.....well i have a bit of movement when i grab the wheel top and bottom.I replaced the wheel hub with a new one and put on the car.problem there still.Put it on the mot testers ramp and he done the suspention test.He said my wheel bearing is shot.i said cant be i just changed it.so he says it gotta be the spindle.I really dont no guys.Vanzep,why do you have to be in scotland lol.im in east sussex damit

if im looking for a rear arm assembley,what ones fit the bb4.Are they all the same,4th and 5th gens.obviously i would need my 4x 114 hubs but is the 4ws ones the same.sorry for my prelude noobness

bb4lightweight wrote: ↑

Fri Aug 13, 2021 7:28 am

well i have a bit of movement when i grab the wheel top and bottom.I replaced the wheel hub with a new one and put on the car.problem there still.Put it on the mot testers ramp and he done the suspention test.He said my wheel bearing is shot.i said cant be i just changed it.so he says it gotta be the spindle.I really dont no guys.Vanzep,why do you have to be in scotland lol.im in east sussex damit

It sound like it is a rear hub that you need, which is the bearing and hub combined.

This is an example as I'm sure you could get it cheaper hunting around.

https://www.ebay.co.uk/itm/270391317589 ... XQ9MVRh7j9

BB4 hubs are non abs - i have one here which came off a BB4 and was working fine - its a genuine Honda part so should do the job. Its an easy job to replace the hub

Edit: sorry to answer your question on rear arm assembly - any 4th gen one (2 liter 2.2 non vtec, 2.3 litre and 2.2 vtec ukdm or jdm auto or manual)will do - as always your best to go for one of same exact model and year if you can but you can still use one with abs but will have few minor differences such as abs ring and sensor. I wouldnt bother with 5th gen ones - i once briefly had a few 5th gens and one them had receipt for set of new wheel bearings and a further receipt a few weeks/months later for another new rear wheel bearing on one side..i dont really know if it is worse wheel bearing on 5th gens or if it is the folks who drive them