or something like that
need it fast thats probobly the reason why i have high rpm's all the time
cause i cleaned all throtle body and even bougth a special sprays didnt help
Posted: Sat Sep 15, 2012 9:03 am
by mercutio
can you explain the problem?
Posted: Sat Sep 15, 2012 9:29 am
by jonja
when i start engine its 3 000rps ( usualy when it gets warm , rpm goes down to 800) now when its getting warm rpms start to jump from 1 000rpm to 3 000rpm then when i drive like this like 10min, rpms goes down to 2 000 rpm and stays when i switch of the engine , and start again, everything is the same, rpms jumping
Posted: Sat Sep 15, 2012 9:36 am
by andypont
Not sure, but it could be the the IAC valve needs cleaning.
Posted: Sat Sep 15, 2012 10:32 am
by jonja
ive cleaned it several times, but nothing changes
Posted: Sat Sep 15, 2012 10:46 am
by vtectom
I had this problem & what you've probably done is up-set the tps voltage;
it all started when i went to 6000 rpms with warm engine
i will check it later
Posted: Sat Sep 15, 2012 1:32 pm
by Merlin
Have you checked the FITV?
Posted: Sat Sep 15, 2012 1:46 pm
by jonja
Nope, but still thanks for suggestions
Im gonna go and do it now
Posted: Sat Sep 15, 2012 6:43 pm
by jonja
I think it might be FITV because when i took it off, that plastic thing inside wasnt screwd in, so it was moving by itself, only problem that i broke 2 screws what was locking FITV cause they were rusty as hell , and now its in service , they try to take out old screws out, in 3 mechanic places they just sayd that they wont do that , and i found one where they gonna try to do it.
And i watched a youtube video about how to take it out and guy sayd that if you have high rpm then that plastic thing should be screwd in to the end, and if they too low then you have to screw it out as posible, so mine even wasnt screwd, so i hope that was the problem
thats my problem
thats probobly the reason why i have high rpm's all the time 
didnt help
what was locking FITV cause they were rusty as hell , and now its in service , they try to take out old screws out, in 3 mechanic places they just sayd that they wont do that , and i found one where they gonna try to do it.