Page 1 of 3
H22A2 Parts Search
Posted: Fri Jan 18, 2013 12:02 pm
by serik
Hello. I need P13 ECU EUDM. And P13 injectors with knock sensor.
Does anyone have it?
Posted: Fri Jan 18, 2013 12:17 pm
by Merlin
Welcome to LG!!
The H22a2 and H22a5 do not have a knock sensor from the factory so if your running a UK / European P13 you dont need one
I think I have a UK P13 sitting spare. I will have a look.
Where are you from?
Posted: Fri Jan 18, 2013 9:09 pm
by serik
I come from Germany.
I know that EU P13 ECU have no knock sensor, I also have one at home P13JDM ECU and thus does not want to run.
Engine is a H22A5.
Posted: Fri Jan 18, 2013 9:11 pm
by mercutio
@Bri should have the bits you need eudm p13 dont have knock sensors though
Posted: Fri Jan 18, 2013 9:23 pm
by Bri
If Merlin dont have one I will sort you out, I have one or two
Posted: Fri Jan 18, 2013 9:51 pm
by serik
Let us be ...
I Prelude BB2 (2.3)
Did they swap H22A5.
Tried to move it with P13 JDM ECU.
It is not runing,reports knock sensor.
Already have an OEM off and on E-Bay.
345cc injectors are OBD1 drine, ignition is set correctly.
Posted: Fri Jan 18, 2013 9:54 pm
by mercutio
so you have a ukdm h22 and a jdm ecu so all you need is a ukdm p13 ecu and you will be golden unless you want to run the jdm ecu in which case you will need the knock sensor
Posted: Fri Jan 18, 2013 10:00 pm
by serik
I have H22A5(EU) with P13 JDM...
Posted: Fri Jan 18, 2013 10:50 pm
by mercutio
but its in place of a h23 so will already be obd1 so right on the level i was on
Posted: Fri Jan 18, 2013 11:35 pm
by mercutio
doesnt mean he is using the obd2 harness or inlet or injectors maybe the op should post up what exctly he has done with the swap
if he has a p13 in then he cant be using the obd2 harness it wont plug in