Lude Generation

I'm looking for a rear ABS sensor, mine has died

Cheers!
William

The 4th gen Honda part number is 57475SS0951 and the 5th gen is 57475S30000, which could be the same part.

Merlin wrote: ↑

Fri Jul 07, 2023 9:43 am

The 4th gen Honda part number is 57475SS0951 and the 5th gen is 57475S30000, which could be the same part.

Thanks for the Tip, I will investigate this! Possibly the connector is different but that should not be to hard to replace.

looks like rockauto do them but out of stock on left hand side ones - bit pricey tho
they also do a connector and wires for the front ones if you want to repair what you have - might be ok for using the connector on the rear - you would have to check
https://www.rockauto.com/en/moreinfo.ph ... xPwA%3D%3D

connector & wires

https://www.rockauto.com/en/moreinfo.ph ... xPwA%3D%3D

vanzep wrote: ↑

Wed Jul 12, 2023 3:44 pm

looks like rockauto do them but out of stock on left hand side ones - bit pricey tho
they also do a connector and wires for the front ones if you want to repair what you have - might be ok for using the connector on the rear - you would have to check
https://www.rockauto.com/en/moreinfo.ph ... xPwA%3D%3D

connector & wires

https://www.rockauto.com/en/moreinfo.ph ... xPwA%3D%3D

Oof that's pricey indeed. But if there's no alternative I could always look at this. Thanks

wllm wrote: ↑

Tue Jul 11, 2023 11:23 pm

Merlin wrote: ↑

Fri Jul 07, 2023 9:43 am

The 4th gen Honda part number is 57475SS0951 and the 5th gen is 57475S30000, which could be the same part.

Thanks for the Tip, I will investigate this! Possibly the connector is different but that should not be to hard to replace.

From what I read online on another forum, front is interchangable between 4th and 5th gen but rear is specific to generation. Just to be sure I'll try to get 4th gen rear sensors. Swapping a connector is something I'm not afraid of

I've found a set rear sensors in Germany!

You can swap left/rear sensors on a 4g, if you open up the tabs on the metal brackets to swap the cables (the cable length/plug/sensor etc are identical)
It's risky though, because you're forcing the cable to bend 180^ the opposite direction that it has done for years previously...