Page 1 of 1
Hugo. 1995 UKDM BB1 track hack
Posted: Fri Jan 16, 2015 10:26 pm
by chrismc
http://youtu.be/ttGXdJv8eNY
Dyno run!
Jdm ecu & spoon copy chip
JAPspeed mani & modded downpipe (2.5" collector)
JAPSPEED resonated decat
Fujitsubo Legalis R system
K&N typhoon intake
206bhp/153lbs/ft
Posted: Sat Jan 17, 2015 9:15 am
by wurlycorner
For an h22a2? That's pretty good.
how comes using a Jdm ecu rather than chipping a Ukdm ecu?
Re: Hugo. 1995 UKDM BB1 track hack
Posted: Sat Jan 17, 2015 10:28 am
by chrismc
wurlycorner wrote:For an h22a2? That's pretty good.
how comes using a Jdm ecu rather than chipping a Ukdm ecu?
Yes it's an A2. Responded well to the mods!
I don't think the UKDM ecu is chippable- whereas I bought the JDM ECU socketed then bought one of the Spoon copy chips from Rob on here. Straight swap.
Tried the Rev limited & non limited versions. No discernible difference in power
Posted: Sat Jan 17, 2015 1:56 pm
by wurlycorner
You can chip some Ukdm ecu's, depends on the particular model number of your ecu IIRC (the one in my Ukdm can and will eventually get be chipped!).
I thought running a Jdm ecu on an a2 was a bad idea because firstly it's tuned for a different compression engine and secondly it will be looking for a knock sensor (which it won't find)?
Do I have that wrong?
Re: Hugo. 1995 UKDM BB1 track hack
Posted: Sat Jan 17, 2015 3:12 pm
by chrismc
Mine runs spot on with the JDM. I was worried about the difference in CR from h22a to a2 but it runs great
CEL illuminates after a few miles but as its a track car it's no drama.
I just make sure not to be greedy with ign timing