Page 1 of 2
New to the forum - h23a3 motor issue
Posted: Fri Jan 30, 2015 10:47 am
by Wrenchin_Rosie
Hey Ya'll... Im Rosie
was wondering if someone could help me with a h23a3 motor issue i have in my 92 Lude?
i just put in a new water pump and broke timing belt...my helper did while i was n the bathroom... but they didnt mark the pulleys and continued to change pump. got it all back together and went to start and sounds like utter jobby have to hold gas pedal down to keep it runningput pulleys to all marked positions and still no good idle or n e thing... uggh please help me!
Posted: Fri Jan 30, 2015 12:46 pm
by ek9sid
Hello and welcome. I presume the crank was in the correct position?
Posted: Fri Jan 30, 2015 2:07 pm
by Merlin
Welcome to LG!!
Perhaps pull it to bits again, set the timing marks to the correct positions and put the belt back on?
Posted: Fri Jan 30, 2015 6:00 pm
by mercutio
Merlin wrote:Welcome to LG!!
Perhaps pull it to bits again, set the timing marks to the correct positions and put the belt back on?
this ^^^^^^^^^ take off the belt retime all the marks refit the belt away you go assuming you havnt damaged the valves
Posted: Fri Jan 30, 2015 6:22 pm
by wurlycorner
Welcome.
H23A3? That's an unusual engine code. Where are you?
Yep, what they said is the best plan of action now.
Let us know how it goes?
Posted: Fri Jan 30, 2015 7:05 pm
by Doggo
Welcome in
And good luck with it.
Posted: Fri Jan 30, 2015 9:56 pm
by Kawa
Welcome to LG
Posted: Mon Feb 02, 2015 8:08 am
by Wrenchin_Rosie
thanx for the welcome guys... yes im n cali northern in fact and yes crank was alligned correctly but i didnt know about marking the timing mark on the 15 b4 tdc.... so we will try that tomorrow and im affraid that we did bend the third intake valve unfortunately
it sounds like it is a tooth off it wont even idle almost like a vacuum hose was backwards.... i got smooth exhaust sound normally but now wen i hold pedal down it sounds like a scooter... weve taken this thing apart 6 different times now doin different stuff so i think i might just buy a whole new top end and get a turbo while im at it... any input?
Posted: Mon Feb 02, 2015 8:14 am
by Wrenchin_Rosie
also my motor is stamped H23a3 ive looked into it quite a bit... just quick question would i be better off putting a H22a? or keep the same head it has... i dont know the history of the motors miles cuz i got it out of a wrecked 93 lude from a junk yard... all i know is the work ive done to it so far. idk what brand cams and lifters and valves i should get?
Posted: Mon Feb 02, 2015 10:19 am
by Lude-dude
H23a3 is this the blue top 2.3 vtec?
worth saving if you can, or maybe you can swap for normal h22a head?
I have supertech valves, my valvetrain snapped one my standard valves but no problems since I fitted the supertech's
think they are made in cali too, skunk2 is the other option
cams I would go with skunk2 stage 2, I have crower stage 2 but might have made more power with the skunks