Lude Generation

Hi
Could someone who has swapped the 5th gen glass roof onto the 4th gen prelude vtec BB4 give me some information. Had the car for 10 years now no rust anywhere on the car its never failed an MOT yet but the sun roof has rusted badly. I brought a glass roof off jazz1889 a member on here just waiting for him to post it. My question is before I start drilling the brackets is I've read on other sites some people who have done this conversion have said it fits OK others have said it sticks up 10mm above the roof & have removed the headliner & dropped the hole unit with shims so it sits flush but some have also said the rubber S ill doesn't sit tight to the roof even after dropping it so I was wondering if anyone has experienced any leeks, if so I might have the original metal one shipped over from the USA the cost is about £250 delivered as I can't find a new one or a none rusty one anywhere in the UK any help would be appreciated. THNX

guide here
http://www.ludegeneration.co.uk/honda-p ... t4839.html

Hi not swapping the complete unit only the glass. I've got the gist how to do it I just want to know if anyone who has done the swap has found that It leeks before I drill the brackets!

@cliveozy

I've recently done the glass into 4G conversion.

You can use the 5G brackets but this is what causes the front to sit proud by 10mm or so.

Retain the 4G brackets and drill them out to fit the 5G roof and you will find it sits quite nicely. Mine sits proud by around 3-4mm but isn't really noticable. At least with this you will only need to shim the mechanism slightly if you so wished.

I've not had any leaking issues so far

You can see the pictures on this page of my profile thread: http://www.ludegeneration.co.uk/profile ... 3-360.html

Thnx

That's great then 3 or 4 mm I can live with that, I'M going to use my original brackets Tape the 97-01 roof bracket on top of the 92-96 Sunroof bracket so all slider mounting holes line up & drill new holes & grind down the metal/rubber bump stops.
Your car looks awesome. many thnx for the info.

I'll be honest, due to the design you can't get them on top to line them up well enough and they'll just get in the way.

Hold them up so you can see where you need to cut, then just grind it out bit by bit until the glass panel sits in.

I'll try. I saw on another site that someone bolted them together before drilling as the outer mounting holes will line up.
If not will go your way of doing it. thnx again.

Yeah the outer mounting holes line up, but due to the way they bend you can't get them to sit together very well!!

I did that to get a rough idea where to cut, but after that it was trial and error