Door not opening from inside.

Rocky · Post by **Rocky** » Thu Dec 20, 2012 11:52 am

Hi Guys.

My drivers door won't open from the inside, it works fine from the outside though.

It's been getting steadilly worse over the past couple of months so it seems something is gummed up or needs greasing.

Is there an easy way to grease the mechanism without taking the doorcard off?

Post by **indigolemon** » Thu Dec 20, 2012 11:58 am

Clearly your car loves you and doesn't want you to leave. And no, doorcard off I'm afraid.

Supermarine Blues · Post by **Supermarine Blues** » Thu Dec 20, 2012 12:59 pm

You could cut a hole in the doorskin with an oxy-acetylene torch or an angle grinder.

Probably easier to take out the three screws & unpop the door card. I'd lube it sooner rather than later, before the exterior one starts playing up, too.

Rocky · Post by **Rocky** » Thu Dec 20, 2012 1:06 pm

indigolemon wrote:Clearly your car loves you and doesn't want you to leave. And no, doorcard off I'm afraid.

Ah feck! Was hoping I wouldn't have to do that with all the rain we're having.

Post by **Merlin** » Thu Dec 20, 2012 2:02 pm

Getting a 5th gen door card off is a bit of a ball ache first time round, you need to remove the interior wing mirror trim, remove the speaker from the door, unhook the inner handle rod, and disconnect the wiring for the window/mirror switches and courtesy light before the door card comes off. I would study the service manual before trying to take it off. The manual also shows the location of all the door card poppers so you can precisely prize the door card off

Also make sure you wind the window down before you try and take the door card off otherwise it will be near impossible. You might need to plug the window switch back in to wind it up while the door card is off so you can get access to the handle mechanisms.

NCCMUR · Post by **NCCMUR** » Thu Dec 20, 2012 2:50 pm

The problem will probably be the little clip that the door rod goes into
To check this simply remove the screw where the chrome interior handle is, disengage from door trim and have a look to see if the rod is still connected.
If its not this then as said before you'll need to remove the full door trim to investigate.

julienh · Post by **julienh** » Thu Dec 20, 2012 4:26 pm

http://www.handa-accessories.com/prelud ... ortrim.pdf

Rocky · Post by **Rocky** » Thu Dec 20, 2012 4:39 pm

NCCMUR wrote:The problem will probably be the little clip that the door rod goes into
To check this simply remove the screw where the chrome interior handle is, disengage from door trim and have a look to see if the rod is still connected.
If its not this then as said before you'll need to remove the full door trim to investigate.

I don't think it's this, it sometimes works.

Best way to describe it is like a toilet that wont flush.......a couple of pumps of the handle and it sometimes works.

Supermarine Blues · Post by **Supermarine Blues** » Thu Dec 20, 2012 5:30 pm

Merlin wrote:Getting a 5th gen door card off is a bit of a ball ache first time round, you need to remove the interior wing mirror trim, remove the speaker from the door, unhook the inner handle rod, and disconnect the wiring for the window/mirror switches and courtesy light before the door card comes off. I would study the service manual before trying to take it off. The manual also shows the location of all the door card poppers so you can precisely prize the door card off

Also make sure you wind the window down before you try and take the door card off otherwise it will be near impossible. You might need to plug the window switch back in to wind it up while the door card is off so you can get access to the handle mechanisms.

Been a while, but I think I managed to slide it under the mirror trim & I'm unsure about the speaker (KFC-1666s).

But at this time of year, you may well break some of the clips as they get brittle in the cold.

Actually. if you can unprise the rear edge clips (lose the screws) and peel back the weather membrane, you might be able to spray with WD40 & hope that works until the weather improves.

Post by **Lude-dude** » Thu Dec 20, 2012 5:58 pm

was gonna say the plastic clip, they break so remove the handle carefully

dont pull it out too far, till you remove the clip connected to the rod