Page 1 of 3

how to fix 5th gen window problem

Posted: Tue Feb 21, 2012 3:10 pm
by Slashdotdash
Right im sure alot of you have had this problem in the past well heres how ive fixed both of mine :)

Things you will need:

10mm socket
Rachet
Extention bar
Pozi screwdriver
80 Grit sand paper
Silicon lubricant or WD40
A Tube of Sikoflex/ Glass bonding silicone sold at halfords


First off remove the door card

Image

Then position the runner where you can caccess the window clips, the runner actually slides left and right so you can position them where you like :)

Image

Image

Image

Carefully remove the glass and take it somewhere flat to work on, clean the previous adehsive off and sand to give the new adehsive something to stick to, i used 80 grit decorators sandpaper :)

Image

Image

Image

Then clean the gunk out of the clips

Image

Image

Lube the rubber runners, try to get right in the back, silicon lubricant works best but i didnt have any lol

Image

Then fill the clips up with the sikoflex/window bonding sealant (be VERY carefull with this stuff it wont come out of clothes or fabric!)

Image

Bolt them back in

Image

Then raise the runner to about here

Image

Image

And carefully lower the glass back in making sure its correctly seated in both clips

Then wind the window right up making sure its all correctly aligned and leave for a couple of days, avoid Mcdonalds drivethru also ;)

Image

Posted: Tue Feb 21, 2012 3:19 pm
by JayJay
Added to Wiki for you :)
http://www.ludegeneration.co.uk/wiki/in ... ywork_Bits

I've called it "How to Replace 5th Gen Door Glass" as I was unsure how to properly describe it :lol:

Posted: Tue Feb 21, 2012 4:42 pm
by Slashdotdash
Great, yeah i didnt really know what to call it lol

Posted: Tue Feb 21, 2012 5:04 pm
by nitin_s1
Good job. I did the same thing on my old Prelude. 8-)

Rep points.

Posted: Tue Feb 21, 2012 5:45 pm
by A1ex
Good work :D

Posted: Tue Feb 21, 2012 6:34 pm
by Pushki
Great write-up!! 8-)

Posted: Wed Feb 22, 2012 12:44 am
by Slashdotdash
Save having to re post these pics anyone know what will get that gunk off the door the best?

Posted: Sat May 04, 2013 1:41 pm
by taz8520
Does this fix the alignment issue where there is a gap along the top front edge ?

Posted: Sun May 05, 2013 9:45 am
by wurlycorner
Is this a common problem on 5ths then?
Can't work out why it would be on them and not on 4ths as all the basic design/assembly method looks the same? :huh:

Great write up/pics btw.

Re: how to fix 5th gen window problem

Posted: Thu May 29, 2014 8:32 am
by Pre_luda_Chris
My problem with the windows is the passenger side stayed down and lost power to pull it up and down. Any similar problems anyone?