Lude Generation

I had to adust my brake pedal sensor to cure a crusie control problem.


On both pedals there is a sensor.


1. Disconnect the sensor wiring.

2. Use a 14mm spanner to slacken the nut.

3. Rotate the senor to get it to the desired position, tighten the nut and reconnect the wiring.

I'm surprised you have to disconnect the plug. Is the system smart enough to reset on re-connection or something?

Mind you, I didn't know these sensors existed: I'd never thought about them. It makes sense: use the pedals and the cruise control switches off. Is it just an in-line micro-switch?

They are just ordinary push button switches, with the system looking for an earth via each, when you press the pedal, the earth is cut and the system turns off.

By disconnecting the plug you dont twist the wring while adjusting the sensor

This gives me somewhere to start as I discovered the cc on the 5th gen isn't working.

Is the button on the rhs of the dash supposed to light up or stay depressed when pushed before setting the speed? Mine does neither.

Should light up from memory bud

There's a green light on it that should light up.
can't remember if it's meant to stay depressed as well

The cc master switch stays depressed and lights up
then set as normal
i had to adjust the switch on the clutch pedal to get mine working
exactly the same procedure as merlins guide

My cruise control packed up about a month ago can anyone send a pic of the switches that need to be adjusted as I will give that a go