Page 2 of 2
Re: Abs 1-2 error code
Posted: Thu Mar 24, 2016 8:43 pm
by c_doughty1
Do you know how to bleed them by any chance I don't I haven't done it yet
Posted: Thu Mar 24, 2016 8:53 pm
by uberNoobZA
c_doughty1 wrote:Do you know how to bleed them by any chance I don't I haven't done it yet
Nope sorry - Got a mate helping me. We did my Civic when I changed calipers, but that was just removing air bubbles, not a full flush. It was a 2 man manual job with one guy pumping brakes, and another releasing clamp on end of brake line to let brake fluid come out. This went on and on until each brake line showed no more bubbles. Then onto next brake.
Posted: Thu Mar 24, 2016 9:12 pm
by wurlycorner
That doesn't bleed the small part of the ABS system that c_doughty is talking about.
Re: Abs 1-2 error code
Posted: Thu Mar 24, 2016 9:58 pm
by c_doughty1
wurlycorner wrote:That doesn't bleed the small part of the ABS system that c_doughty is talking about.
Do you know how to remove the valve on the abs to bleed it? Or an alternative tool that may work.
Posted: Thu Mar 24, 2016 10:18 pm
by Vtecmec
I think you need specialist tools to bleed the abs, plus its under a high pressure. It's the reason I just bypassed my code 1 and left alone......
Re: Abs 1-2 error code
Posted: Sat Mar 26, 2016 5:28 pm
by c_doughty1
Vtecmec wrote:I think you need specialist tools to bleed the abs, plus its under a high pressure. It's the reason I just bypassed my code 1 and left alone......
I may have to take it to honda then.....
Posted: Fri Apr 29, 2016 6:05 am
by kkalle
You will need a "T-wrench", honda special tool. Shouldn't be a problem to borrow one from your local honda dealer. The bleeding prosses is rather easy.
Jump the abs relay for max 10 seconds, then open the nipple at the pump/motor with the t-wrench. Close nipple again.
Just be careful, due to the possible high pressure.You don't wanna spray brakefluid everywhere.