Lude Generation

Pushki77 wrote:‘De-lemoned’ My Headlights
A common problem with cars that have plastic headlight covers, is that after a few years the lacquer they use to coat the headlight turns yellow and flakes off in places.
It brings down the whole look of the car.

This was what my headlights were like and it really bugged me.

I considered buying new headlights but couldn’t justify spending over £100, so there had to be another way. :-k

I searched the forum and found this;
jules.pollocks 'Restoring JDM Plastic Lights!' thread.

I’ve shamelessly stolen photos from Jules’ thread for illustration purposes only as I always forget to take ‘before & during’ pictures.
Cheers Jules, royalty cheque is in the post. :^o

The headlights start off looking like this.
Mine weren’t quite as bad, but the method is the same however bad they are.



I used slightly different products from Jules, but the trick is to use finer & finer abrasives until you have a crystal clear surface.

The first important step is to mask the surrounding paintwork.
Then using a fine wet’n’dry paper, sand the headlight evenly all over until all traces of the lacquer are gone.
This is the scary bit because you’ve made it look worse than before.

I used 3M Fine P600 wet’n’dry, and I kept it wet with car shampoo. This created a nice abrasive paste.

Your headlight should look something like this.
Notice the patch of lacquer still to be removed.



Once all trace of the lacquer is gone, wash off the residue.

The next step is to use a finer abrasive. I used Autosol chrome cleaner paste.
Work it in evenly all over, and you will notice the cloudyness disappearing.
Take your time, because the more scratches you remove now, the better the results later.

You headlight should be looking like this now.
Still a bit cloudy but a lot better.



Once you’re happy that you’ve gone as far as you can with the Autosol, it’s time to get granny's Brasso from the scullery. :-s

Do the same again with the Brasso. Work it into the corners and edges, and take your time. The more effort you put in, the better the results.
When you think you’ve done enough, do it some more. [smilie=hate-adolfsisi.gif]

For the final step, you will need a dedicated plastic polish.
I used Meguiar’s PlastX, with a microfibre cloth.
Same again, more rubbing……………Your arms will ache, you may ‘hit the wall’, but carry on and go for the ‘burn’. [smilie=hate-sonno.gif]
This is the stage where you remove the microscopic scratches to get that ‘crystal clear’ look.

When you’ve finished, stand back and admire your hard work. [smilie=hate-bravo2.gif]
No time for standing around for too long though, you’ve got the other one to do. [smilie=hate-mazzata.gif]

At a guess, I’d say it took me about 2-3 hours each headlight.
Here’s what mine looked like afterwards.




Credit to jules.pollock..............Cheers Jules [smilie=hate-king.gif]

tramroadmotors wrote:ukdm are glass but still a real crap beam.