Lude Generation

Reset ABS Fault Codes

The procedure to reset the ABS codes is as follows:

- Plug in a paper-clip to the blue service connector under the dash.

- Press the brake pedal and hold.

- Turn the ignition key to the second position (not starting the car).

- When the ABS light goes out take your foot off the brake.

- The light will come back on, press the brake pedal again and hold.

- After the light goes out, release the pedal.

- The light will blink twice to indicate the DTC code was erased.

Hi, I've just tried this but it didn't work? Tried it 3 times.

With the pedal pressed when the ignition is turned on the abs light flashes it's code, when it stopped and wasn't on I let go of the pedal it then flashed the code again. It did not go out or flash twice? Just keeps showing me damn code.
Really wound me up lol

I thought to clear the abs code on a 4th gen you just pulled the ABS ECU fuse out and left it for 10mins or so?

Ah really? This option sounds better lol I'll try that