Page 1 of 1
Boost: H22 vs. H23
Posted: Thu Jul 17, 2014 12:53 am
by Sailor
A chap I met but don't know very well told me that the H23 will take a higher boost than an H22 when both have stock internals.
He reckoned the H22 would manage 5-7 psi, which probably sounds about right. He wasn't sure about the H23 figure, but seemed sure that it could end up with more flywheel hp without compromising reliability.
I'm not convinced. Could it be true?
Posted: Thu Jul 17, 2014 12:57 am
by 4thgenphil
Sounds like bollocks to me, the blocks are near identical, they are lower comp so could take more boost but have less power to start with.
Posted: Thu Jul 17, 2014 10:51 am
by rob quilter
Yep, bollocks. 2.0 would hold more boost though.
Posted: Thu Jul 17, 2014 11:18 am
by JMBW
I think that would only be possible if it was a H23A DOCH VTEC, (H23A bottom end + H22 head) ... just seams like a lot of hassle for little gains, this set up probably will give you some more low end torque and better spool time. And as for reliability - I also suspect it would be insignificant, as the blocks/internals are very similar.
Posted: Thu Jul 17, 2014 3:01 pm
by Sailor
Good.
I did wonder if my BS detector needed an overhaul.
Posted: Sun Nov 16, 2014 3:25 pm
by prahunt
JMBW wrote:I think that would only be possible if it was a H23A DOCH VTEC, (H23A bottom end + H22 head) ... just seams like a lot of hassle for little gains, this set up probably will give you some more low end torque and better spool time. And as for reliability - I also suspect it would be insignificant, as the blocks/internals are very similar.
Does this mean by swapping my head on my H23 I could give myself VTEC, a H23A DOCH VTEC relatively cheaper?
Interesting......
Posted: Sun Nov 16, 2014 5:21 pm
by JEBB4
@prahunt I know they do it with the b series and d series engines (mini me conversion)..
theres a good chance its possible with the H too..
would involve some wiring or loom swap mind..
Posted: Sun Nov 16, 2014 6:53 pm
by 4thgenphil
It is possible prahunt although a little more complicated than just swapping the heads To get the best from it and make is semi reliable
Posted: Sun Nov 16, 2014 7:15 pm
by prahunt
JEBB4 wrote:@prahunt I know they do it with the b series and d series engines (mini me conversion)..
theres a good chance its possible with the H too..
would involve some wiring or loom swap mind..
4thgenphil wrote:It is possible prahunt although a little more complicated than just swapping the heads To get the best from it and make is semi reliable
That's fine, I expected more work would be involved. But it's good to know its possible.
