H22A8 exhaust o2 sensor wiring missing?

[Merlin]

Anyone know what colour wires there meant to be and which pins on the main plugs so I can trace back? Any suggestions as really doing my head thankyou all

Take a picture


Below is a pic of a 4th gen setup (the O2 sensor connectors are slightly different) but it shows the location on the H22 engine loom. It is to the right of the oil filter.

Connector on the loom


O2 sensor (bad pic)

http://www.ludegeneration.co.uk/post301775.html#p301775

[IanPreludeuk]

Thanks for the help are the wires on o2 sensor the same colour as the loom?

[Merlin]

You would assume so but I have never had the need to check. Check your engine loom, it will be there. It might even be bracketed to the stand of the intake manifold.

[IanPreludeuk]

Ok have another look tonight might take the casing off the loom if nothing seen thanks

[IanPreludeuk]

Found no wiring for o2 sensor. Traced the wiring back on my h22a8 loom there are 2 wires missing in the plug which is grey and should have 8 pins in it and plugs to the dash loom. wires are white and black/white and are the centre two of the plug closet to front of vehicle if anyone can check there h22a8 would be much appreciated. The plug has rubber bungs in it where the pins/wires should go but they look original. My original loom which is a f20a4 has all the pins in that plug? Engine didn't have front pipe or o2 sensor if anyone has one for sale would buy thanks all

[Merlin]

@IanPreludeuk I think I have a JDM 5th gen engine loom that I can sell if you are interested. It will fit the H22a8 perfectly, in fact it is the only other loom that will fit the H22a8 and its ancillaries.

What ECU are you using? The stock H22a8 ECU?

[IanPreludeuk]

Got the stock ecu that came with it but it's no problem to add the wires as got to add the wires to dash loom as well. I'll just go for it and see what happens hoping to start the swap in 2 weeks so I let u know how it goes thanks