Auto to manual

Post by **newkid** » Wed Mar 24, 2021 10:45 pm

What's all needed to swap a 5th gen from auto to manual.

Flywheel
Clutch
Gearbox
Brake and clutch pedals.

What else?

Post by **ek9sid** » Wed Mar 24, 2021 10:57 pm

Gear linkages? Clutch master/slave cylinders + lines

Post by **4thgenphil** » Wed Mar 24, 2021 11:30 pm

Drive shafts and half shaft

Post by **4thgenphil** » Wed Mar 24, 2021 11:31 pm

Isn't there a reinforcement plate for the clutch master cylinder required for a 5th gen aswell.

Post by **Vtecmec** » Thu Mar 25, 2021 8:01 am

Brozilla · Post by **Brozilla** » Thu Mar 25, 2021 8:35 am

Vtecmec wrote: ↑
Thu Mar 25, 2021 8:01 am
ECU?

You can convert auto ecu to manual with a simple resistor relocation. As a bonus, you can take out two rare transistors used to trigger solenoids in auto transmission and use them for VTEC conversion/boost control conversion on another ECU.

Post by **vanzep** » Thu Mar 25, 2021 9:34 am

^interesting info there

you might also need a manual starter motor - i have one here for you

Post by **Drax** » Thu Mar 25, 2021 10:17 am

viewtopic.php?f=5&t=18720&p=308275&hili ... ap#p308275

ive added this to the guides/how to/tech section