Page 1 of 1
best way to remove rust spot's off stainless manifold
Posted: Sat Nov 02, 2013 10:44 am
by preludemanh22
had my manifold bead blasted it's been hanging around in the garage
anyone point me in the right direction ? THANKS.
picture's
Re: best way to remove rust spot's off stainless manifold
Posted: Sat Nov 02, 2013 10:49 am
by mills
Looks
you could try a bit of autosol
Posted: Sat Nov 02, 2013 10:56 am
by preludemanh22
that could be a good option
just dont want to mess it up
Posted: Sun Nov 03, 2013 2:56 pm
by SPYDOR
Unless it has a special coating then Autosol's Metal Polish sounds like a good idea. Should blend in after airing for a few days.
That fanimold does look good, shiny welding, oooh!
Posted: Mon Nov 04, 2013 8:20 am
by BMCC
You could use :
http://www.halfords.com/webapp/wcs/stor ... yId_165594
Polished my valve cover with one of these.
Posted: Mon Nov 04, 2013 9:42 am
by lewd lude lover
dont think he wants to polish it. just remove the rust spots.
Posted: Mon Nov 04, 2013 12:09 pm
by BMCC
lewd lude lover wrote:dont think he wants to polish it. just remove the rust spots.
Sure but to remove the rust your going to have to polish it a bit. One of the compounds is a slightly agressive cutting compound so it should remove the rust spots fairly easily, if you want to get a good shine you could use the other compounds.
It more expensive than autosol but if you do it right it will remove those spots permenantly as some of the metal has to be removed otherwise the rust will just bubble back up. You need to get to good clean metal again. The cutting compound will do this.
Posted: Mon Nov 04, 2013 3:10 pm
by SPYDOR
Nice, must get one of these metal polishing pads sometime as they can work wonders
