Lude Generation

Does anyone know where to get one?
I heard there is one on H22A5 (5th gen). Can anybody confirm this? Also metal flywheel cover and small aluminum brace that runs between the block and the tranny doesn't get used. It need an aluminum piece that bolts to the tranny and the new oil pan. Do you have a part number or something?

Thanks in advance

If you want an alloy sump you can get one off an H22a5 or H22a8. They are 5mm deeper than the 4th gen H22a / H22a2 sumps.

Are you doing anything special with it?

K30DPC wrote:metal flywheel cover and small aluminum brace that runs between the block and the tranny

What engine is this for because the a2 one is quite different to the a5/a8 stiffener plate.

Merlin wrote:What engine is this for because the a2 one is quite different to the a5/a8 stiffener plate.

JDM H22A P13

#1 in this pic?



COVER, CLUTCH CASE - 21350-PT0-000

Yes mate that is the one ( I believe ) Can You get part number please?

Is there any additional seal?

I found this


So I need to buy 9,13 and 1 from your pic? Am I right?

Oh and 38 is different (longer)

The part number is at the bottom of my last post. From memory I don't think there is any thing else to it.

Duh I get blind when I seen this pic. I get so excited

Thanks a lot. 2morrow I go to order it

+rep

K30DPC wrote:Oh and 38 is different (longer)

#38 on the pic you posted? They are guide bolts that should be in the bottom of your block. You should be able to reuse your old nuts.

I checked part details and the one for alloy pan is 4mm longer. I'm doing complete rebuild so few quid doesn't make a different so I'm gonna change all bolts, studs and nuts for some stainless steal.

One more think. Is the oil pick up pipe the same?

I've got a spare ally sump and gearbox brace if you need it mate?