Page 1 of 1
Intake Control Solenoid Valve
Posted: Fri Jul 18, 2014 9:27 am
by Drax
can this be removed? I see it missing from a lot of lude engine bays with aftermarket cold air intakes?
as it's in the way of fitting my CDA cone
Posted: Fri Jul 18, 2014 9:32 am
by Merlin
Yes you can remove it. Just make sure you block the vacuum hose on the intake manifold.
Posted: Fri Jul 18, 2014 9:37 am
by Drax
Merlin wrote:Yes you can remove it. Just make sure you block the vacuum hose on the intake manifold.
marvellous, thanks Merl
Posted: Fri Jul 18, 2014 9:45 am
by bb1boy
What engine is that exploded diagram a picture of?
Posted: Fri Jul 18, 2014 10:09 am
by Drax
bb1boy wrote:What engine is that exploded diagram a picture of?
Guide says H23
Posted: Fri Jul 18, 2014 10:46 am
by bb1boy
Ah right, fair enough mate, I thought you had an H22.
Posted: Fri Jul 18, 2014 11:05 am
by Drax
bb1boy wrote:Ah right, fair enough mate, I thought you had an H22.
I do have an H22
just the lude manual only shows either F20, F22 or H23 for this section, and the H23 is very similar anyway to the H22
Posted: Fri Jul 18, 2014 11:52 am
by Vtecmec
The H22 vacuum diagram is in one of the suppliments (different file), though looking at it I don't think there are any differences anyway.
Posted: Fri Jul 18, 2014 12:30 pm
by Drax
Vtecmec wrote:The H22 vacuum diagram is in one of the suppliments (different file), though looking at it I don't think there are any differences anyway.
good to know
cheers!
Posted: Fri Jul 18, 2014 12:33 pm
by DaveyBa8
Yea they all seem pretty much the same, I've deleted almost all vacuum lines, map sensor and the heater matrix vacuum thingy, which dosent seem to be needed (straight pipe will do) so really just the map sensor and fuel rail valve.