Page 1 of 2
How much to sleeve an H22?
Posted: Wed Aug 13, 2014 12:24 pm
by NafemanNathan
Anyone got a good idea/experience of how much I should be paying an engine builder to sleeve an h22?
It'd be to standard bore (more than likely), but I'm considering custom pistons and it'll give me a lot more options if I can go forged.
@ddoubledanny, you didn't get your quote itemised by chance did you?
Posted: Wed Aug 13, 2014 12:51 pm
by RattyMcClelland
It would be around 1k including custom sleeves. I'm exploring this route with darton mid wetters.
My bro in laws garage rebuilt a focus st and the engine block got machined, bored and resleeved at graham Goode for just over 1k.
Posted: Wed Aug 13, 2014 1:14 pm
by NafemanNathan
Kind of the ball park I imagined. Cheers Scott.
Posted: Wed Aug 13, 2014 2:34 pm
by ddoubledanny
I've gone for Darton mid wet sleeves all in with machine work was £1200
Posted: Wed Aug 13, 2014 2:37 pm
by NafemanNathan
Cheers Dan
Posted: Wed Aug 13, 2014 3:35 pm
by 106pete
Have u seen the guy breaking a atr turbo on Facebook? It just states a forged bottom end, maybe some use to you?
Posted: Wed Aug 13, 2014 3:45 pm
by NafemanNathan
Ooo, got a link?
Posted: Wed Aug 13, 2014 4:54 pm
by 106pete
It's on HONDA PARTS FOR SALE the guys called jay kullar
I'm not sure if it's been removed as I can't find it now but maybe just pm him over Facebook
Posted: Wed Aug 13, 2014 5:12 pm
by NafemanNathan
Cheers Pete. I've just sent my request to join.
Posted: Wed Aug 13, 2014 7:01 pm
by RattyMcClelland
ddoubledanny wrote:I've gone for Darton mid wet sleeves all in with machine work was £1200
Who did/or is doing the work?