Page 1 of 6
H22 problem 6500rpm
Posted: Wed Feb 04, 2015 8:21 am
by Dogg1210
So my h22a7 has went a bit wrong somewhere car pulls like it should in 1st and 2nd but when in 3rd just after vtec comes in it's like it hits a limiter at 6500 rpm then in 4gh it doesn't seem to engage vtec at all anyone have the solution lol cheers
Re: H22 problem 6500rpm
Posted: Wed Feb 04, 2015 9:13 am
by clarelude23
Check for leaks around the VTEC solenoid and check your oil level is topped up. Start there anyways mate
Posted: Wed Feb 04, 2015 9:23 am
by bluejackhustler
Is your check engine light illuminated? Sounds like limp mode, does your VTEC definitely engage?
Posted: Wed Feb 04, 2015 9:28 am
by Dogg1210
Defo engages mate. It only seems to hit the 6500 limit in 3rd oil levels are good. No leaks from vtec solenoid. It won't do it for about 10mins after it's heated up and if I turn car off for say 10 mins it works fine but then it'll happen again after 10mins driving???
Posted: Wed Feb 04, 2015 9:38 am
by bluejackhustler
Paper clip test to get the ECU fault codes (if any) and report back.
Posted: Wed Feb 04, 2015 9:40 am
by Dogg1210
Will do this tonight would a faulty O2 sensor cause this ?
Posted: Wed Feb 04, 2015 9:45 am
by clarelude23
Maybe no harm to take off the solenoid and clean your screen gasket. After that,see what fault codes it throws up.
Posted: Wed Feb 04, 2015 9:47 am
by Dogg1210
Yeah mate goin to take solenoid off tonight clean and see what codes are on cel
Posted: Wed Feb 04, 2015 9:47 am
by Vtecmec
Yes, I'd be checking the spool valve gasket too.
Posted: Wed Feb 04, 2015 9:48 am
by clarelude23
^^^^^^sorry dogg1210,only saw your post afterwards.