Page 1 of 1
New belts
Posted: Wed Mar 11, 2015 9:31 am
by andyconnolly
Where's the best place to get new belts for the car ie timing belt etc... Going in for a full service to get oil, filters Sparks and belts done
Also best place for a wheel bearing ?
Posted: Wed Mar 11, 2015 9:47 am
by Merlin
I got my timing belt and balance shaft belt from Honda. I think they were £60 odd combined.
Euro Car Parts do a Continental timing belt for £17
http://www.eurocarparts.com/ecp/c/Honda ... e0a&000336 And they do timing belt kits
http://www.eurocarparts.com/timing-belt-kit
Are you replacing the timing belt tensioner? What mileage is your car? Thought about doing the water pump while you are in there?
Posted: Wed Mar 11, 2015 10:01 am
by andyconnolly
The clock reads 153k
Would it be worth while doing the tensioner ?
Never thought about the water pump ? Should that be done aswell?
Posted: Wed Mar 11, 2015 10:05 am
by Merlin
Yes and yes

With the age of the car it would be wise to do both while you are changing the belts.
You could go for a new OEM tensioner, H23 manual tensioner conversion or the Kaizenspeed manual tensioner. All will be around the same price. Also best not to scrimp on the water pump. Me and
@Vanzep compared cheap water pump Vs OEM and the cheap one had smaller impellers.
Posted: Wed Mar 11, 2015 11:53 am
by andyconnolly
Cheers

will look into it then
Is the manual tensioner better than the auto one ?
Posted: Wed Mar 11, 2015 12:00 pm
by Merlin
The auto tension will be fine however there is the chance that it may fail. The chance of it failing is greatly reduced when you fit a new one. The auto tensioner is reportedly fiddly to install as you need something to compress it while installing.
Re: New belts
Posted: Wed Mar 11, 2015 12:20 pm
by andyconnolly
The manual sounds better then
£90 for the conversion kit? Or can you get them cheaper than that?
Posted: Wed Mar 11, 2015 12:43 pm
by Merlin
That is the going rate. It take a little thought to install the manual kit but its not difficult. The Kaizenspeed manual tensioner is pretty much plug and play from what I have read.