Lude Generation

Hi chaps. Apologies if it's been covered elsewhere as I'm sure it has! I've searched but keep drawing blanks or finding info on 4G's.

How do I pull codes from a 5G? It's OBD2 as far as I can tell, but there's no socket for a code reader!

It's a mates car - he had a new exhaust section made and he had a new O2 sensor fitted. It's thrown a code - hopefully because they had it running wth the sensor unplugged...

Try disconnecting the battery for a few mins to reset.

Tried it and the light came on again. Does the ECU flash to give the codes or is there a jumper somewhere to get them off the dash?

I've done it on an accord euro R (obd2) there was a 24 pin socket that 2 pins needed bridged, it then flashed the EML on the dash, I'd say the fault still exists if the light is still there.

http://honda-tech.com/forums/honda-prel ... st38252637

Worth a look

There's a 2 pin socket in the passenger footwear, behind a little carpet flap on the dash side. Just jump it with a paperclip or something similar and turn the ignition on (but not engine) and the eml will flash to signify the error code

Bingo! Cheers Sid.

No worries. Always happy to help where I can