Page 1 of 3

Gen 3 jerking when accelerating?

Posted: Sun Apr 16, 2017 5:18 pm
by bees
Hi guys, my B20a7 89 gen 3 man prelude is jerking under acceleration. It idles fine, but when driving, in the transition from light to medium throttle pressure, it hesitates than peaks and repeats...

Checked the usual stuff and just did distributor timing, no difference.

Any ideas?

Cheers Bees.

Posted: Sun Apr 16, 2017 8:11 pm
by James 5th gen
This happened in my girlfriends car and once we changed the fuel filter it was completely gone, it was a turbo diesel car so it may be different. However i know its better to try the cheaper things first.

Posted: Sun Apr 16, 2017 8:21 pm
by Vtecmec
Fuel filter is a good shout, also O2 sensor if it's FI.

Posted: Mon Apr 17, 2017 7:04 am
by bees
Cheers, done the fuel filter twice now, the first one didnt fit perfectly. No difference. Will try tps throttle position sensor and 02 sensor and let you know how i get on.

Posted: Mon Apr 17, 2017 10:30 am
by NafemanNathan
Is this when the engine is hot or cold or both?

Also, can you replicate the issue stood over the engine?

Posted: Mon Apr 17, 2017 4:04 pm
by bees
Hi, it does it hot or cold but it wont do it stationary, only when driven (under load). Really obvious, bounced along, almost undrivable. No codes showing and have reset.

Hope that helps...???

Posted: Mon Apr 17, 2017 4:23 pm
by Andyjess666
I had a old saab an it used to do something what you had after a lot of head scratching turned out to be the rotor arm so I changed dizzy cap an rotor arm an fine from there on might be worth a check

Posted: Mon Apr 17, 2017 4:28 pm
by RattyMcClelland
Timing sounds out.

Posted: Mon Apr 17, 2017 4:42 pm
by bees
Had the strobe light on it. It was out by a couple of degrees but but its made no difference. It runs like a dream on the drive ( stationary).

Posted: Mon Apr 17, 2017 5:36 pm
by mercutio
plug leads