NafemanNathan wrote: ↑Fri May 24, 2019 4:18 pm
What have you spotted Dan?
loose starter motor and loose throttle cable
njord wrote: ↑Fri May 24, 2019 4:35 pm
Is it right through the rev range or just at a certain rpm.
You like leaving stuff loose
as soon as you start revving it, right through the rev range. it doesnt get any worse as the revs go higher, but you can only notice the vibration in the cabin, so im still convinced maybe the rear engine mount is split/splitting although they all look ok-ish
![Laughing :lol:](./images/smilies/icon_lol.gif)
Nick you know me far too well!! as mentioned above, i noticed these were loose
starter as i'd only used 1 bolt as i couldnt find the other one when putting the engine back together, so i've re-tightened it and made up another bolt using one slightly too long but with spacers to tighten it properly.
the throttle cable i'd be adjusting since the tune as it had a lot of slack in it and you could tell, as there was a delay to revving the engine but it was then balancing the rev's being not too high and not too low to stall. ideally i need Bri's timing gun now to put it on course with the flywheel. i obviously hadnt tightened the two bolts enough
im going to remove the cam cover later to check if anything has moved in the head, maybe an adjustable cam gear has slipped or something im just guessing now. she starts and drives fine, but you can tell something isnt right with this vibration.