4g OEM Exhaust mid section flange mounting studs

chrismc · Post by **chrismc** » Sun Jun 24, 2012 8:43 pm

Im after a new OEM stud & nut to fit a 4g VTEC exhaust mid pipe

The studs are the jobbies that fit into the midpipe flange to connect it to the rear section...

Can't find them anywhere though I'm sure I've got hold of them for an Integra before...much the same as those fitted to an OEM Cat IIRC?

Any help gratefully appreciated!!!

Chris

Post by **Merlin** » Mon Jun 25, 2012 9:34 am

Won't any old nut and bolt do it?

Post by **rob quilter** » Mon Jun 25, 2012 9:35 am

Merlin wrote:Won't any old nut and bolt do it?

Should do, stainless fixings FTW!

bristol_bb4 · Post by **bristol_bb4** » Mon Jun 25, 2012 9:37 am

Lmao as said, its a nut and bolt.

chrismc · Post by **chrismc** » Mon Jun 25, 2012 10:31 am

Hmm-not quite that simple

The OEM stud has an anti-rotation flat on it that engages against a raised section on the flange- thus a nut/bolt is not really viable

Post by **Merlin** » Mon Jun 25, 2012 10:38 am

Personally I would just slap anything on there, and have. If I read you correctly, angle grind or file a flat side to the bolt head. If you need an OEM bolt I would just get it from Honda.