what goes into the hole
Posted: Thu Nov 08, 2012 12:52 pm
[insta]http://instagr.am/p/RxObomkuNE/[/insta]
Page 1 of 1
Posted: Thu Nov 08, 2012 12:53 pm
Can i just plug that hole up thanks
Posted: Thu Nov 08, 2012 12:55 pm
Block that hole. 
Posted: Thu Nov 08, 2012 12:58 pm
Posted: Thu Nov 08, 2012 1:39 pm
Wrong question to be asking on this forum 
You've already got one breather hose connecting the induction pipe to the valve cover, so that one isn't necessary.
Love the purple anodizing on your injector resistor box by the way
You've already got one breather hose connecting the induction pipe to the valve cover, so that one isn't necessary.
Love the purple anodizing on your injector resistor box by the way
Posted: Thu Nov 08, 2012 1:40 pm
That hole is for the H23, not needed for your engine.
Posted: Thu Nov 08, 2012 2:12 pm
Its normally smaller than that on most intakes. That hole IS in use on a UK H22A motor. Its not needed for the JDM H22A. It connects to a small pipe which is suspended over the intake manifold. Its something to do with idle though as I found out. Without it connected the revs didn't drop when off the throttle, when changing gears.
Posted: Thu Nov 08, 2012 3:57 pm
PTFE Tape & a screw, job done.