Lude Generation

hi would i see any gains by just bolting on an s2000 throttle body?
only thinking of doing this as ive been offered one for free and it will completely remove the fitv.
cheers Jon

IIRC it's a 62mm bore. Bolting onto a stock intake mani without port matching I'd say probably no.

I thought it was larger then that. In that case it is the same size as the Type-S / H22a7 / H22a8 TB. I can't remeber if your running an ATR intake manifold

I did a quick search and lots of places report the Spoon one being 70mm, with some blurb about Spoon making it 16% larger than stock, so 62mm would be about right.

Dunno if this helps anyone but I found a list of Honda throttle bodies and sizes

b18c1 60
b18c spec R 62
b18a 58
b18b 60
b16a SiR 58
b16a Sir2 / b16a2 60
b16a3 58
b20b/z 60
f20c 62
d15b7 56
d16a6 55
d16y7 56
d16y8 56
d16z6 56
ZC 55
d16a1 55
d16a8 55
h22a / h23a 60
f22 / f23 60

@4thgenphil was running one on his old setup, he'll know

A1ex wrote:@4thgenphil was running one on his old setup, he'll know

His mind has degraded over time from too much consumption of alcohol, so I wouldn't bet your bottom dollar on it.

4thgenphil wrote:the s2k TB is the same size as the atr one but opens up into a slightly bigger taper and sits a little differently on the manifold, if you already have an atr TB and manifold i would just use that as you will get no real gains from using the s2k one, i only did as it was gas flowed .

Found in a PM from 8-9 months ago

NafemanNathan wrote:

A1ex wrote:@4thgenphil was running one on his old setup, he'll know

His mind has degraded over time from too much consumption of alcohol, so I wouldn't bet your bottom dollar on it.

Not far from the truth.

Cheers @a1ex