Lude Generation

Does anyone know, or can they look where this vac line goes to at the other end?



I can't find reference to it in the manual or any of the supplements. I think it might just t into another vac line as I have no loose ends, but not sure?

Thanks in advance.

Which line are you talking about? I can see 2 vacuum lines in that pic that aren't connected to anything? (1 top middle, 1 middle left).

What's the other end of the vac line connected to? I did a thread about some vac lines on my ludes a while ago, had variouspics of vac lines on a ukdm and jdm because I noticed they weren't the same and wanted to check that was right (it is). If you Do a search in my posts, should find it? That might help answer the question?

Sorry, it's the one connected to the (heater device?) in the middle, that vanishes up out of the picture, where is the other end supposed to go? Just checked the entire car referencing the service manual, but this is flapping around with nowhere to go and I can find no reference to it.

I'll have search after my tea.

there you go man

oh yea and that does a full loop right around to that black circle looking thing with the grey plug, to the right of the map sensor.

ran outside there and found the remains on the old lude.

Thanks Davey, now I am confused.

I'd found an old pic of the car showing it going to the same spot and assumed it was incorrect, but when checking page 11-3 of the VTEC supplement, that should go to the EVAP cannister at that end and the purge control solenoid at the other? Your EVAP is piped into the general vacuum via a t piece, which again is different than the manual.

mmm, its number 13 on the sheet your looking at? the bypass control diaphragm that vac line (13) then goes to the bypass control solenoid. my EVAP T piece as i remember goes straight to the intake mani, and then off to intake control solenoid box so according to the sheet number 8 and you see with the dotted lines is the T piece. looks ok to me man. i might have a few more pics if your stuck

actully yea i see the confusion now but thats where i goes man, that purge solenoid valve is the confusion

No, not 13, but number 3. According to that EVAP small top pipe should lead to the pipe pictured, and then onto the purge control solenoid. Number 8 (dotted line) is not a t-piece in the diagram, but carries on under the intake pipe and wraps round to the left port on the far side of the throttle body.

heres exactly where the EVAP lines go, one to throttle body, one directly behind trottle body on intake mani, and if you look at the first pic i posted one goes to a hard line connected beside fuel lines.

so yea you where right all along and my pic conforms it there for ya it just loops around, head scratching stuff lol

yea but that pic you posted is number 13 thats the bypass that controls the coolant for the heatermatrix. you cant see number 3 in your pic. i think that diagram is abit off as i dont even no if we have a purge control solenoid

am so confused now to, but thats where EVAP lines go and thats where the diagram on the water line goes, it just loops lol