5th gen Haych twenty two Engine Mounts

'92 Si VTEC · Post by **jjmartin349571** » Fri May 24, 2013 9:54 pm

Could you take a closer photo of the N/S engine mount please Ratty? I think it might be the answer to my H22A Accord problems. Is it fluid filled like on a 4G or solid rubber?

Post by **RattyMcClelland** » Fri May 24, 2013 10:01 pm

Pretty sure they are all solid rubber.
I get pics of all up. To me they are all in great nick.

The "S" express · Post by **honda-hardy** » Fri May 24, 2013 11:20 pm

5th gens are just rubber mounts.

'92 Si VTEC · Post by **jjmartin349571** » Fri May 24, 2013 11:52 pm

Awesome. I've done a bit of searching on eBay and it looks like the 5th gen mount bolts to the chassis in the same locations as the mount on the 6th gen Accord. I'm assuming that the stud/hole on the engine are the same distance apart on both early H22's and the later ones? As this is the reason the engine mount from the Accord wasn't suitable, the F20B6 stud/hole were miles apart compared to on the H22A I've got. Sorry if that's a bit vague but I don't know what else you'd call them

How much would you be after for the mount Ratty? I'm fairly confident this is what I need to finally get my engine bolted in

Post by **RattyMcClelland** » Sun Jun 02, 2013 1:59 pm

Some pics One mount is split through the middle

The "S" express · Post by **honda-hardy** » Mon Jun 03, 2013 12:34 am

i notice they all have MT bonded in the rubber, is this manual transmission. @gordonlear has an auto. gordon, does yours have mt or at bonded in? if you do not go down the poly bush route, this is still beter than the one you have on yours, and it would bond with sikoflex better. and you can leave it to bond for weeks rather than days.

'92 Si VTEC · Post by **jjmartin349571** » Mon Jun 03, 2013 10:16 am

@RattyMcClelland Any chance of a few good photos of the nearside mount and bracket? I think I need it for my H22 swap. Cheers

Post by **RattyMcClelland** » Mon Jun 03, 2013 11:08 am

jjmartin349571 wrote:@RattyMcClelland Any chance of a few good photos of the nearside mount and bracket? I think I need it for my H22 swap. Cheers

Will do that tonight.

Post by **RattyMcClelland** » Thu Jun 06, 2013 5:52 pm

'92 Si VTEC · Post by **jjmartin349571** » Sun Jun 09, 2013 11:45 pm

@RattyMcClelland If the engine bracket is held on by a nut then that should do me

How much you after for it delivered mate?