Lude Generation

What chips will i need for a 1995 BB1 ukdm and a 1994 BB4 jdm.
I done this years ago but there are more chips now so not sure which ones to buy.
Thanks

anyone?

@ the OP.

Are you still supplying these please? I'm at the point where I need a new ECU to make use of the mods I've done and some others I have there to bolt on.

@Hagland-BB4
1995 BB1 ukdm (second chip) - while this chip fits a UKDM ECU, it is very specific. It will only fit UK ECU’s with the ECU sticker part number ending in ‘G00’
1994 BB4 jdm (first chip) - this will run fine

@TitzonToast
ill chase up Rob now who supplies these for you

Much appreciated. Thank you very much.

Not sure if this is the right thread
Currently my prelude runs on an P28 with Neptune RTP but for archiving purposes I dumped the rom from my EDM P13 (37820-P13-G00). An unknown tune for an H22a2. It has a key101 "protection". I dumped the eeprom with key101 attached with an Xgecu T56 programmer. Maybe it's useful for someone and I'm also interested in the changes compared to the stock rom.

I would not advise anyone to just burn this rom and go with it, maybe if you are skilled you could have a look at it the engine was blown where this ecu came from so....

https://pw12.nu/STATIC/prelude/p13chip/AM27C512_32.bin

my 4g Lude was a f20a4 engine and now has a H22a1 fitted the car is a BB3 ukdm which had a P11 ecu, I have the choice of two ecu's a p27 and a p13 G01 what would the best ecu to fit and what chip to use. NB. the ecu harness on the ukdm is different pinout to the usdm and jdm, iv'e added in the vtec and knock sensor wires which weren't on my f20 harness

@Drax were you ever able to speak with Rob?

wurlycorner wrote: ↑

Tue Feb 06, 2024 8:30 pm

@Drax were you ever able to speak with Rob?

i did at the time, he said he'd take a look but im guessing it passed him by. i can chase him again