Lude Generation

Due to wanting some space I am offering up my old Type S engine for sale.
It measured 211.2 on the last dyno. It would be a fantastic base for a rebuild. It smoked a little and it was losing a bit of oil but nothing major. Most of the oil leaking on to the drive was from what turned out to be a crack in the gearbox however it does have a few weapy oil seals and gaskets. What ones leak? I have no idea.
This engine is the jdm h22a Type S different to the h22a fitted to 4th gens, this engine is an ideal donor for a Type S owner and not ideal to put into another non Type S Lude without a massive ball ache as it doesnt have the drive shaft support casting in the rear of the engine block.

as featured in this post.
http://www.ludegeneration.co.uk/post232874.html#p232874

Any offers welcome. collection from near chippenham wiltshire. you will need a van and an engine hoist. if you have no hoist, i can load it at my end but then you would need to be able to lift it off at your end.

I will pop up a picture of it as it sits in my garage later this evening.
It will be just the bare engine, including sump, block and cylinder head, oil pump and complete with cams
None of the manifolds, plastic covers or rocker cover will be included.

Any questions please ask.

here are the pics as it sits.

bump. offers via pm, need this gone.

Hi H.H. We are having a meet on the 22nd March at Portsdown Hill mid-day. Fancy rallying the troops from your area and popping down?

prelude91 wrote:Hi H.H. We are having a meet on the 22nd March at Portsdown Hill mid-day. Fancy rallying the troops from your area and popping down?

@prelude91 replied in meet thread

I'll take it

As agreed.

Good bit of networking going there, following todays meet -up. Hope you both enjoyed the afternoon.

it was good. my bald head looks like a red beacon