Lude Generation

Posted: **Fri Jun 26, 2015 7:59 pm**

This was bought from Crigal_bb6 and this was the add:

PLM tri-y header/ manifold. (hytec replica). One of the best on the market. Best performance mod i have ever bought for any car. Big bhp gains. Hardly used as my engine deveoped a nasty knock and i never got round to fitting it to my new prelude. Not sure if you can buy these in the UK anymore. £425 new. Offers? Looks much darker in photos. Would clean up easily.

Got this for £300.

£250 collected.

Posted: **Fri Jun 26, 2015 9:26 pm**

Cheeeeeeeeap!!!

I would certainly have this off you Nits if I didn't already have the Mugen.

Posted: **Sat Jun 27, 2015 8:47 am**

remind me... Front subframe needs notching slightly in order to fit this, that's all, right?
Provisional dibs please...

Posted: **Sat Jun 27, 2015 11:48 am**

wurlycorner wrote: remind me... Front subframe needs notching slightly in order to fit this, that's all, right?
Provisional dibs please...

front subframe needs notched and your cat/decat needs to be extended to meet up plus a mating connector. Should have a connector pipe but it will have been used on car that it came off.

Posted: **Sat Jun 27, 2015 1:19 pm**

I might need this for the wagon. As I think my stock Manifold is blowing

Posted: **Sat Jun 27, 2015 9:18 pm**

Yep good point newkid, should it have a donut seal and short pipe section back to the cat?

and if so, does it match up with an fgk section for that part? If so, I am in business, even with it missing on nitins...

Posted: **Sat Jun 27, 2015 9:51 pm**

Fgk wont match up as thats 2.36" wereas the plm is a true 2.5". Its easy made up by an exhaust place. Even with the short piece ud still need it mated up to cat/decat. If like my old one its going on a bb4 just have the center section extended doing away with cat/decat.

Posted: **Sun Jun 28, 2015 8:20 am**

Already have a genuine TRM decat pipe available

so would need to get the section in between done.
nitin_s1 did that part not come from crigal? If not, @crigal_bb6 do you still have that piece?
If not, then as you say, I could get it made up.

Thanks.

Posted: **Sun Jun 28, 2015 10:37 am**

Wurly, what's in the pic is in the sale.

I was going to fit this and get the rest of the exhaust made up so didn't research about the middle pipe bit.

Posted: **Sun Jun 28, 2015 12:33 pm**

Nitin dont worry about it. Even with that part as one end is blank an exhaust place would still be needed.

Lude Generation

PLM Tri-y exhaust manifold and downpipe

PLM Tri-y exhaust manifold and downpipe