Loads of 5g 2.2 bits, nothing special

[Scott560]

Before the old vti went to the scrapyard, I pulled off loads of bits. They have been sitting boxes in the garage for 18months so it's unlikely I'll need them in the future.

Would rather someone made use of the parts than bin them.

If you see something you like, enquire and I'll check the condition etc. All came off a 97 2.2 vti manual h22a5.

Will post pictures first, then listing of what is in the boxes (this might follow an hour after the first post)

Cheers,

Scott

Sent from my MIX using Tapatalk

[Scott560]

Mystery box number 1 contents:

Generic induction kit with silicon joiner. Have cleaned the filter but probably wants oiling. Gone

2 standard prelude 5g grills (both gone)
Pair of standard rad fans in working condition.
Pair of foglight blanks.
Standard 3rd brake light
Wood center console trim, light scratched. (gone)
Drivers and passengers dash vent (outer)
Ashtray (rear)
Stalks
Rotary coupler
Electric window switches
Pair of standard tweeters
2 red door open warning light /puddle light
Passenger window switch plus trim in wood (lightly scratched)
Ignition switch (main power bit)
Mirror switch
Battery hold down clamp plus 1 long rod thing.
Ignition transponder pickup ring
Spare wheel and tie down bracket thing
1 interior wing mirror panel trim (cheater?)
Decat (too short for h22a5)
Glove compartment lock in beige plus 2 holding bush things
Some random bits of loom I probably cut off along the way.

[Scott560]

Mystery box number 2:

A shed load of wing mirror parts. Glass, inner and outer covers, brackets and base plates etc. All a bit nackered but enough to fix faulty ones. Some in Burgundy, blue and white. None of its mint. Left over from folding mirror rebuild...

Interior fan motor + fan blade in working condition
Engine bay fusebox lid
Rubber headlamp bulb seals
Coolant idle thing (iacv?)
Braided clutch line, came with car , never fitted.
Gearbox reverse sensor
Pair of horns
Dizzy cap, rotor and leads and plugs. Removed from working car.
1.6kw starter plus some loom (gone)
Ps pump
Alternator
Brand new coil
Fuel filter (new)
Thermostat (new)
Another coil (screw snapped off in thread)
Coolant expansion tank.

[Scott560]

Mystery box number 3.

Rear oil cooler oil seal brand new
P5m ECU (manual h22a5)
4ws ECU
Throttle body minus TPS sensor
Remote locking ECU plus fob (Gone)
Main relay, broken mount (Gone)
Accel pedal assembly
Door switches
Rear light clusters
Clock plus hazard switch
Cruise ECU
Abs ECU
A/C heater control panel
Cruise switches
All relays
The other interior wing mirror trim
Another pair of foglight blanks (gone)
Switch pack missing the cruise switch
Random plastic ECU, suspect this is the body ECU?
Orange side repeaters (2 pairs)
Interior light dome in beige
Petrol plus boot lever caps
Fuel inertia cut off switch
Bits of loom (mostly connectors with bit of wire from above items)

[Scott560]

Mystery box number 4.

4 front indicators. 1 chipped lense, 1 slight broken mounting tab (where screw is) enough to make 1 good pair. (Gone)
Cruise actuator with bracket and vacuum resoivoir thing and cable
Yellow connector coolant temp sensor
Both front ABS sensors , working
Resonator air flap control valve and box thingamajig
Brake fluid cap with wires/sensor
Another set of fog light blanks (seriously where do these come from)
EGR valve
Mirror control switch with momentary push folding mirror button - rare lol (no relay so don't ask)
Working distributor with no coil (but have the rest)
2 engine bay vacuum solenoids. Most likely evap purge control and runner flaps?
Vtec solenoid
Any relay or big fuse....
2 standard vti front callipers. Gone - now have some more available!

[Scott560]

Also set of 4 standard vti 16inch 5 stud wheels with 5mm+ tyres. Bit rough but all legal and hold air. Removed from old car. Probably have almost all the nuts aswell

Sent from my MIX using Tapatalk

[James 5th gen]

Locking ecu thing and fob please my fob dosent work and never remembers the fob after programming, this might sort it out

[Scott560]

Locking ecu thing and fob please my fob dosent work and never remembers the fob after programming, this might sort it out

Sorry, someone else PM'd me about 10mins ago for it!

Sent from my MIX using Tapatalk

[Free Ranj Egg]

How much do you want for the induction kit mate? Will it fit a H22a8 engine?

[Scott560]

How much do you want for the induction kit mate? Will it fit a H22a8 engine?

It came with my h22a8 lude (in the boot along with other previously fitted items) so assume it was fitted at some point. It has a couple of witness marks which leads me to believe it was fitted. Car has a type S intake currently. Off to a funeral today so no time to to try and refit it.

£25 quid posted?